About NDT Procedures

Insure the quality and consistency of your inspections through the use of clearly written NDT procedures. Procedures are written specifically for your needs addressing your specifications and are delivered in editable, electronic format (typically MS Word) as well as PDF.

Listed below are some of the procedure we can supply. If the procedure you require is not listed here please submit an RFP by clicking here.

• Procedure for the Qualification and Certification of NDT Personnel
• Fluorescent Liquid Penetrant Examination Of Aircraft Components
• Magnetic Particle Examination of Aircraft Components
• Magnetic Particle Examination
• Liquid Penetrant Examination
• Fluorescent Liquid Penetrant Examination
• Radiographic Film Processing
• Procedure For Controlling The Quality Of Industrial Radiographic Film Processing
• Radiographic Examination, IAW ASME Section V, Article 2
• Radiographic Examination, IAW AWS D1.1 and ANSI/AAHTO/AWS D1.5
• Radiographic Examination IAW API Standard 1104
• Ultrasonic Instrument Qualification
• Ultrasonic Examination IAW ASME Section V
• Ultrasonic Examination IAW AWS D1.1
• Ultrasonic Thickness Gauging

Procedure Review

If you already have written your NDT procedures, we can review them to insure that they meet the applicable codes. William Blum, has conducted more than 880 reviews of 465 individual procedures submitted by organizations from throughout the world. He co-authored the article “Successful NDT Procedure Development” printed in the October 1997 issue of Materials Evaluation.  Submit your procedure via email for a quick review.

Ultrasonic Examination IAW AWS D1.1

Ultrasonic Examination IAW AWS D1.1

This purpose of this procedure is to provide instruction and define the responsibilities for conducting ultrasonic examination to the requirements of the referenced documents on welds or materials.

Ultrasonic Examination IAW ASME Section V

Ultrasonic Examination IAW ASME Section V

This purpose of this procedure is to provide instructions and establish techniques for the manual ultrasonic examination (UT) of full penetration butt and T-joint welds from 10 mm to 150 mm thick (3/8 inch to 6 inches) in wrought (rolled, drawn, forged, or extruded) and cast materials as required in accordance with requirements of the referenced codes or standards.

Ultrasonic Thickness Gauging

Ultrasonic Thickness Gauging

This purpose of this procedure is to provide instruction and define the responsibilities for conducting ultrasonic thickness gauging to the requirements of the referenced documents on welds or materials.